Digitus
Ikke kategoriseret
DN-93501
Digitus DN-93501 Brugsanvisning
Her er Digitus DN-93501 (Ikke kategoriseret) brugervejledning. 1 sider på sprog Engelsk med en vægt på 0.4 Mb. Hvis du ikke kan finde svar på dit problem Spørg vores community.
Side 1/1
1
3
4
2
4 5
5
6
3
Keystone Jack
Installing Instruction
DN-93501
Follow the direction on the colorcoding
sticker to position T568A or T568B wiring,
separate a little space on proper position
and insert the wire pair by pair into each
slot.
Use 110 or KRONE impact tool to
press and cut off each conductor.
Unshielded type
Shielded type
Insert the IDC cap to x these
wires. Insert the cable tie to tight
up the cable jacket and complete
the installation.
30 mm
I.D.C. Cable tie
I.D.C. Cable tie
T568A
Pin 5 White/Blue
Pin 4 Blue
Pin 1 White/Green
Pin 2 Green
Pin 3 White/Orange
Pin 6 Orange
Pin 7 White/Brown
Pin 8 Brown
T568B
Pin 5 White/Blue
Pin 4 Blue
Pin 1 White/Orange
Pin 2 Orange
Pin 3 White/Green
Pin 6 Green
Pin 7 White/Brown
Pin 8 Brown
Strip approximately 30mm of the cable jacket,
and separate to 4 pair each
Cover the Full shield, then
complete the installation.
( Note: Full shield has to insert into this plastic slot )
Slide the cable jacket into
Cable Holder.
Follow the direction on the color coding
sticker to position T568A or T568B wiring,
separate a little space on proper position
and insert the wire pair by pair into each
slot. Use 110 or KRONE impact tool to
press and cut off each conductor
Insert the cable tie to tight up the cable
jacket. Insert the IDC cap to x these
wires.
Problemløsning Digitus DN-93501
Hvis du har læst manualen omhyggeligt, men ikke fundet en løsning på dit problem, bed andre brugere om hjælp
Specifikationer
| Bredde: | 30 mm |
| Dybde: | 20 mm |
| Højde: | 25 mm |
| Produktfarve: | Sort |
| Pakkebredde: | 75 mm |
| Pakkehøjde: | 115 mm |
| Harmoniseret systemkode (HS): | 85369010 |
| Oprindelsesland: | Kina |